Facility Optimization

Facility Optimization

Except for entire mill line,we are also professional in equipment revamping and system optimization to reuse the existing parts, to maximum extent, based on actual working condition and in adoption of most advanced technology, so as to largely save equipment investment and production cost.

 

Facility Optimization

Except for entire mill line,we are also professional in equipment revamping and system optimization to reuse the existing parts, to maximum extent, based on actual working condition and in adoption of most advanced technology, so as to largely save equipment investment and production cost.

 


Prev: no data!
Next: no data!

FEATURES

Revamping 6-high mill into 18-high mill (typical reference)

1.Before revamping,the work roll diameters ranged from 200 to 240mm which were so large that it caused small rolling reduction,too many passes and low efficiency.The minimum thickness could only reach 0.6mm for strip of width 1250mm;

2.After revamping,the roll diameters of 18-high mill is reduced by 120 to 140mm,the minimum thickness reaches 0.25mm with width 1250mm, so the rolling efficiency is increasing significantly by bigger reduction of each pass;

3.Most worn facilities were revamped by reusing the existing parts, e.g. support roll, to lower production cost with higher efficiency.

FEATURES

Revamping 6-high mill into 18-high mill (typical reference)

1.Before revamping,the work roll diameters ranged from 200 to 240mm which were so large that it caused small rolling reduction,too many passes and low efficiency.The minimum thickness could only reach 0.6mm for strip of width 1250mm;

2.After revamping,the roll diameters of 18-high mill is reduced by 120 to 140mm,the minimum thickness reaches 0.25mm with width 1250mm, so the rolling efficiency is increasing significantly by bigger reduction of each pass;

3.Most worn facilities were revamped by reusing the existing parts, e.g. support roll, to lower production cost with higher efficiency.

no data
no data
no data
FEEDBACK

lf there is a need and please send us an email or call.

*Name
Phone
*Email
Address
*Message